Oklahoma City Water Heater Odor Repair

Are you experiencing an issue with foul-smelling odors originating from the water originating from your water heater? It happens occasionally for a few various reasons. Here is what Water Heater Repair Oklahoma City advises to do to make sure your water smells better and to get rid of any terrible tastes soon.

Causes for Oklahoma City Water Heater Odors?

Bacteria getting in the water system is the most typical explanation ones water at home may have smells. If you home utilizes well water or cities that make use of wells for the water source, will increase the possibility of this taking place.

With a water heater temperature level setting of 140 degrees or more will assist in minimizing the growth of microorganisms inside the water storage tank.

Ways to Remove Foul Water Smells

The following directions explain how you can use chlorine bleach to clean a water heater.

The electric or gas leading to the water heater tank has to first be turned off.

Next, the cold water supply off that leads to the tank needs to be turned off.

Open the hot water faucet of the kitchen sink to allow air to enter the tank.

With a a yard hose hooked up to the storage tank drain valve, drain the water inside the water heater.

Then shut the drain valve after it is empty.

The next step is adding the bleach.
If the pipe for the cold water travelling within the storage tank is a flexible hose, unscrew it from the tank. Otherwise, one will likely need to take off the pressure relief valve, which is more involved. For electric water heaters, one of the elements can be removed.

Use a funnel to put bleach inside the tank.
Add 5 ounces of bleach for every gallon of the tank capability.
So if you have a 50 gallon water heater, you will need 250 ounces of bleach, or about 2 gallons.

Hook the water line or pressure relief valve back up again

Fill the tank back up with water again.

Close the hot water faucet of the kitchen area faucet as soon as all the air runs out the line.

Run all the hot water appliances until the aroma of bleach is apparent. We want to get rid of the microorganisms that are in the water lines likewise, not just within the water heater.

Keep the water in the tank and water lines undisturbed for two to 3 hours.

Drain the storage tank once again and refill it. This time allow it to remain for at least 30 minutes and just as before drain it.

Fill the tank back up. Turn on all of the hot water fixtures and let them run until the smell of bleach is gone.

For gas water heaters, relight the water heater pilot light. For electric water heaters, turn the electricity on again.

Additionally, by changing the anode rods, or simply the type utilized can work as the following video demonstrates:

Additionally, by replacing the anode rods, or perhaps the type employed can work as the next video shows:

Odors from Oklahoma City Water Heater

What the Experts Say

According to Soquel Creek Water District, “The smell is the result of four factors that must all be present for the odor to develop. These factors include:

  • A high concentration of sulfate in the raw water
  • Sulfate reducing bacteria, non-toxic to humans (sulfate is reduced to a sulfide state by the bacteria)
  • Little or no dissolved oxygen in the water
  • Hydrogen (a component of water which may be present due to water conditions reacting with the anode)”  Read more here…

Soquel Creek Water District

How is hydrogen sulfide gas produced in a water heater?

A water heater can provide an ideal environment for the conversion of sulfate to hydrogen sulfide gas. The water heater can produce hydrogen sulfide gas in two ways – creating a warm environment where sulfur bacteria can live, and sustaining a reaction between sulfate in the water and the water heater anode.  Read more…

Minnesota Department of Health

Check out some of our other water heater tips in our blog